In-ground bollardsFlat-cap in-ground steel bollard
Ø89–220 mm listed · 900+300 mm height reference · Ø76 mm to drawing
In-ground bollards use a post or a receiver installed below the finished surface. For car parks, shopfronts and equipment areas, decide whether the project calls for a fixed embedded post or a visible post held in a separate ground sleeve.

In-ground bollardsØ89–220 mm listed · 900+300 mm height reference · Ø76 mm to drawing
In-ground bollardsØ219 / 300 mm · 1050 mm reference height · 3 mm wall
In-ground bollards
In-ground bollardsØ114–219 mm · 1400 mm nominal post height · 150 mm embedment reference
QY-CS11 has a flat cap and a lower fixing bar for a permanent installation. Check the fixing-bar position and show the required exposed height and embedment separately on the drawing.
Request a QY-CS11 quoteQY-IGSS01 uses three lower screws to retain the visible post. For a new installation, confirm the receiver details and drainage. For a replacement, send the existing sleeve dimensions and screw positions.
Request a QY-IGSS01 quoteMark the finished ground line on the drawing. Ask the project team to confirm the footing and buried services. State the finish above and below ground and any reflective band requirements.